Bender & Wirth
deutsch english


New: COB Clip-In function

The new COB Clip-In function from Bender + Wirth was presented at this year´s Light + Building for the first time. The booth visitors feedback regarding the new assembly tool was very positive.



The operating principle is very simple: The Clip-In tool has small extensions on the bottom, which grab through fitting holes in the holder. Now, the COB can be fixed between these extensions. As soon as the holder is screwed down onto the heat sink, the tool releases again.

As of now, the Clip-In function is available for all COB holders from Bender + Wirth. It simplifies the assembly of luminaires and light engines a lot. The assembly tool shown here has a handle to further simplify the positioning.


11.04.2018
New: COB Clip-In function

The new COB Clip-In function from Bender + Wirth was presented at this year´s Light + Building for ... [mehr]





11.04.2018
New: Adapter for bayonet optics

Presented for the first time at this year´s Light + Building, the new adapter ring expands Bender + ... [mehr]





NEWS CATALOGUE COMPANY CONTACT DISCLAIMER IMPRINT PRIVACY STATEMENT